In finding out on your CCNA Test and making ready to earn this important certification, you may well be tempted to invest little time https://en.search.wordpress.com/?src=organic&q=토토사이트 studying static routing and head ideal for the greater enjoyable dynamic routing protocols like RIP, EIGRP, and OSPF. This really is an easy to understand mistake, but nevertheless a slip-up. Static routing isn't sophisticated, but it’s a very important subject within the CCNA Test and a beneficial ability for authentic-entire world networking.
To create static routes on the Cisco router, you use the ip route command accompanied by the place network, network mask, and possibly the next-hop IP address or even the area exit interface. It’s critical to maintain that last part in your mind – you’re either configuring the IP handle on the downstream router, or maybe the interface over the regional router which will function the exit interface.
Permit’s say your local router incorporates a serial0 interface having an IP handle of two hundred.1.one.one/30, plus the downstream router that would be the next hop will get packets on 토토사이트 its serial1 interface by having an IP address of two hundred.one.1.2/30. The static route will be for packets destined to the 172.10.one.0 network. Possibly of the subsequent ip route statements could be accurate.
R1(config)#ip route 172.10.one.0 255.255.255.0 two hundred.one.1.2 (following-hop IP handle)
OR
R1(config)#ip route 172.10.1.0 255.255.255.0 serial0 ( local exit interface)
You may as well create a static route that matches just one vacation spot. It is a host route, and it has 255.255.255.255 for your mask. If the above static routes must only be used to deliver packets to 172.10.one.one., the next instructions would do the job.
R1(config)#ip route 172.10.one.one 255.255.255.255 two hundred.one.one.2 (future-hop IP tackle)
R1(config)#ip route 172.10.1.one 255.255.255.255 serial0 ( regional exit interface)
At last, a default static route serves being a gateway of past resort. If there are no matches for your spot during the routing table, the default route will likely be utilized. Default routes use all zeroes for the two the place and mask, and yet again a upcoming-hop IP deal with or area exit interface can be used.
R1(config)#ip route 0.0.0.0 0.0.0.0 200.1.1.two (up coming-hop IP deal with)
R1(config)#ip route 0.0.0.0 0.0.0.0 serial0 ( neighborhood exit interface)
IP route statements appear straightforward more than enough, but the small print concerning the following-hop IP address, the regional exit interface, default static routes, as well as syntax from the command are very important for achievement on CCNA Test working day As well as in the actual planet.